How to Design a 7.5-Digit High-Precision DAQ?
The Data Acquisition System (DAQ) is an indispensable part of modern electronic equipment. It is mainly used to capture signals generated by electronic devices and sensors with high precision, to…
Signal Interference Keeps Popping Up — Where Should You Actually Fix It at the Root?
Hardware design engineers have probably all run into this scenario: the board comes back from the fab, the chips work fine, but communication signals mysteriously start throwing bit errors. You…
What’s the Difference Between Bypass Capacitors and Decoupling Capacitors? An Engineer Breaks It Down for You
I. Why Can't You Ever Tell These Two Apart? Last week while debugging a board, a new intern engineer came running over and asked me: "Is that capacitor next to…
Understanding ISM Bands
The ISM (Industrial, Scientific, and Medical) bands are designated radio frequency bands defined by the Radio Regulations of the International Telecommunication Union (ITU). These bands are set aside for radio-frequency…
What Changes in PCB Design for High-Speed Interfaces When Moving from 100M to 1G?
I still remember when I first started working, I designed a control board featuring a clock operating at tens of MHz and DDR at several hundred MHz. That was when…
The Rise of Collaborative Robots
Robots have long been part of industrial production. For decades, factories have relied on automation to boost production speed, machining precision, and quality consistency. However, the latest wave of industrial…
- 1
- 2
- 3
- 4
- …
- 10
- Go to the next page